b'Pipe Bending Machine 48-60Pipe Bending Data - Superbender [6 cylinders]MetricNominalPipe OD Maximum Wall Thickness by Grade Recommended Bendmm X52 X60 X65 X70 X80 X100 Degree Arc Radius Max degree per (per meter) (meters) 12 meter joint1,219 - - - - - - 1.64 35.05 11.961,270 - - - - - - 1.64 35.05 11.961,321 - - - - - 48.10 1.64 35.05 11.961,372 - - - - - 44.44 1.64 35.05 11.961,422 - - - - - 41.20 1.64 35.05 11.961,473 - - - - 48.17 38.30 1.64 35.05 11.961,524 - - - - 44.88 35.71 1.64 35.05 11.96 1,219mm - 1,524mm PIPE BENDING DATA - ALL DIMENSIONS IN MILLIMETERS Based on 85% efficiency and maximum strength.ImperialNominalPipe OD Maximum Wall Thickness by Grade Recommended Bendinch X52 X60 X65 X70 X80 X100 Degree Arc Radius Max degree per (per foot) (feet) 40 foot joint48 - - - - - - 0.50 115.00 11.9650 - - - - - - 0.50 115.00 11.9652 - - - - - 1.894 0.50 115.00 11.9654 - - - - - 1.750 0.50 115.00 11.9656 - - - - - 1.622 0.50 115.00 11.9658 - - - - 1.896 1.508 0.50 115.00 11.9660 - - - - 1.767 1.406 0.50 115.00 11.96 48- 60PIPE BENDING DATA - ALL DIMENSIONS IN INCHES Based on 85% efficiency and maximum strength.Notes Bending Tables: A cell marked with a dash [-] represents the ability toActual (as opposed to nominal) yield of the pipe.bend up to 2.00 inch thick. For Wall thickness greaterSkill of the operator handling the bendingthan shown, please contact CRC-Evans. machine and mandrel. Figures are recommendations only and do notOrigin of pipe (pipe mill, plate mill, etc.) andconstitute a warranty. quality of pipe. All bends shown include the use of CRC-EvansType of pipe. Spiral seam pipe will normallybending mandrels. Figures given are average and accept only 75% of recommended bend.will vary due to:Type of die and/or bending set being usedThe wall thickness of the pipe. (e.g., polyurethane lining or special radius dies).26'